Team:CIDEB-UANL Mexico/safety labsafetycards
From 2014hs.igem.org
Lab Safety Cards
Objective: Safety Team did this activity in order to accomplish two targets: (1) to make people understand the importance of safety in a laboratory and (2) to help students keep in mind the correct ways to work on laboratory practices Description: Safety involves all the activities performed in the laboratory and gives safe methods for working on them to avoid accidents or injuries, not only for iGEM contestants, but also for general students. For this reason, Safety Team from iGEM CIDEB 2014 designed and distributed some cards that included general information about how people must work on the laboratory in order to perform successfully their practices. The structure for each card was of 12cm x 7cm, including eight recommendations that discussed about how students should follow and perform their practices, including images. |
These cards were delivered by Safety team before an Experimental Science Laboratory practice to students of second semester. The team told them the importance of safety while performing lab work; they also encouraged them to work safer and proceed to give them the cards.
The information contained in the cards was the following:
1.
Remember to always use a lab coat,
long pants, closed shoes and, in case of the girls, tied hair. It’s very
important to avoid accidents with every type of reactive you work with.
2.
Whenever dangerous substances are being worked with it’s necessary to use gloves and protective lenses. Skin and
eyes are very sensitive.
3.
While doing a practice you should
be conscious of what you’re doing. Follow instructions and if you have any
doubt, ask before acting.
4.
If you observe that something
unusual is happening, don’t hesitate to communicate it to the teacher or to a
lab assistant.
5.
Remember that some materials are
heat conductors. If you heat something in the Bunsen burner, wait until it
cools down and take it carefully in order to avoid skin burns.
6.
Hazardous materials are never
thrown away in the drainage.
7.
Never… Never add water to an acid.
When preparing a solution like that, the water goes first, followed by the
acid.
8.
Whenever you finish a practice
remember to leave your workplace and the material clean and in order.
Design:
The cards had the following design:
Results:
The students showed interest in the cards and it was observed that all of them read the information before the laboratory practice began, that was a good sign because they were able to keep in mind the information given while working.
Since they kept the cards with the information, they became aware that safety was not just for that moment, but for all the future lab practices in their lives.